 |
System consist of: A 12 inch length of EMT,
(2) large washers, (2) sliding compression couplings, (2) plenum rated bushings, a
pair of
documentation labels and a package of intumescent
putty. |
 |
You should use a drill
with a level. This will make your Sleeve System look nice and
straight! |
 |
A 6 inch bit extension
for your hole bits works very well. Be wary of what might be in the
walls. |
 |
You
might use one of the washers to mark your hole. Now drill your
perfectly straight hole.
|
 |
Adjust the hardware to allow for equal protrusion on both
sides of the wall. Insert the first half of the System in the hole you made.
There is no need for any caulk between the sleeve and the
wall (behind the washers). Go to the
other side.... |
 |
On the other side of the wall, install the
washer, sliding compression coupling
and bushing. While holding the sleeve firmly in the wall, tighten the set screw on
the sliding compression coupling. Now you may use the
sleeve system as if it
were a roller in the firewall, allowing you to pull cables "un-attended ".
This is a real time saver! |
 |
Tear the intumescent putty supplied with the
system in half. You will need to apply an inch thickness to each end.
If you do not have enough putty, you may purchase a "Fill Kit". It is
an 18 cubic inch stick of putty. Part # FK-1 |
 |
When the cables reach their destination,
install an inch thickness of the supplied intumescent fire stop putty.
Alpha numerically ID your penetration. Be
sure to fill out and apply the labels. Photograph
your System ! |
.jpg)