Threaded Endcaps are
available in 1 - 2 - 4 inch sizes. They come in sets of two. Each Endcap has intumescent putty for when the sleeve is brought back in to
service.
EMT Endcaps are
available in 1 - 2 - 4 inch sizes. Intumescent putty is included.
A (rigid)
Threaded Penetrator with abandoned cables.
A Smooth Penetrator
with abandoned cables.
Remove the
cables and clean up the ends of the sleeve system.
After the cables are
removed, place the
EMT Endcap on the ends of the abandoned EMT system.
Leave the
protective wax paper in the Endcap to keep the intumescent from
contamination.
Tighten the
set screws.
Screw the
Endcap on the end of the abandoned threaded sleeve until the Endcap seats by
hand. Do not over tighten.
An abandoned and reclaimed system.
Take a
digital photo of your sealed system.
Remember - you may use
the intumescent putty when sleeve system is put back in service.
.jpg)
