 |
This device incorporates a 6 inch long Sleeve
that has one end sharpened so as to make it's own hole in the metal
top plate (wooden caps must be drilled). A large round flat washer
is welded on to the sleeve a few inches from the top. A plastic
bushing is provided to protect cable jackets. |
 |
Remove the plastic bushing and select a spot in
the cap just above your cable outlet. Place the sharpened tip
against the top plate. Deliver a blow to the top of the Sleeve
System with enough pressure to cause the Cap Penetrator to pierce
the plate. |
 |
Carefully push the Cap Penetrator down in to the
wall until the washer seats against the top plate. The Sleeve is
slightly out of round below the washer so that as the Sleeve seats,
it will be locked in place. |
 |
Replace the plastic bushing and drop your cables
in the wall and down to the cable outlet. No caulk or putty is
required. The Cap Penetrator allows for a neat and clean looking
cable installation as it protects the cable jackets from damage. |
