This device incorporates a 6 inch
long Sleeve that has one end sharpened so as to make it's own hole in the metal top
plate(wooden caps must be drilled). A large round flat washer is welded on to the
sleeve a few inches from the top. A plastic bushing is provided
to protect cable jackets..
Remove the plastic bushing and select a spot in the cap
just above your cable outlet. Place the sharpened tip against the top plate.
Deliver a blow to the top of the Sleeve System with enough pressure to cause the
Cap Penetrator to pierce the plate.
Carefully push the Cap Penetrator down in to the wall until the
washer seats against the top plate. The Sleeve is slightly out of round below the washer
so that as the Sleeve seats, it will be locked in place.
Replace the plastic bushing and drop your cables in the
wall and down to the cable outlet. No caulk or putty is required. The Cap
Penetrator allows for a neat and clean looking cable installation
as it protects the cable jackets from damage.
.jpg)
